Ezytrim

For Brickwork, Blockwork or approved Fibre cement Texture Sheeting(Refer to building board manufacturer for further Details)

Using Active Building Systems Ezyprep or Ezycoat Coarse Patch( see Ezyspec TDS ) liberally apply a coat of product to the edge to be treated prior to installing the Ezytrim angle. While still wet then embed the Ezytrim angle into the Ezycoat Patch Product ensuring that the 1st application of wet Ezycoat patch squeezes thru the holes in the Ezytrim Angle Bead. At this Point the angle should be position in its final resting place ensuring it is straight & plumb as required. While the Ezycoat Patch is still wet and the Ezytrim angle positioned correctly then a second coat of Ezycoat patch should be applied to the outside of the Ezytrim angle legs so as to ensure a good coverage of Ezycoat patch over the legs of the angle.

The second coat should only be of minimal thickness as per specification, so to allow the second coat of Ezycoat finishing texture or render be applied to the minimum coating thicknesses as specified by the relavant Ezycoat Ezyspec TDS for the product being used. The second coat of patch should be feathered out to its minamum thickness so as to blend in with the wall, however the applicator will need to determine this based on the finishing coat system he has chosen to use. The Ezycoat Patching compounds should then be allowed to fully cure as per the Ezyspec TDS prior to applying any Ezycoat Finishing coats.